Emerson Micro Motion 5700 - Alerts, Conditions, and Configuration Options; Configuration Error; Configuration Warning; Core Low Power

7.2.5 Alerts, conditions, and configuration options
For more information on these alerts, see Status alerts, causes, and recommendations.
Configuration Error
Default severity: Failure
Severity configurable: No
Fault Timeout applicable: No
Table 7-2: Configuration Error conditions
Name Ignorable
[020] Calibration Factors Missing No
[021] Incorrect Sensor Type Yes
[030] Incorrect Board Type No
Core Processor Update Failed Yes
Password Not Set No
Time Not Entered Yes
Batcher Not Configured Yes
[120] Curve Fit Failure (Concentration) No
Configuration Warning
Default severity: Maintenance Required
Severity configurable: Yes
Fault Timeout applicable: No
Table 7-3: Configuration Warning conditions
Name Ignorable
[103] Configuration Warning Yes
SD Card Failure No
No Permanent License No
Clock Failure No
SD Card Full No
Transmitter Software Update Failed Yes
Core Low Power
Default severity: Failure
Severity configurable: No
Fault Timeout applicable: No
Configuration and Use Manual Configure device options and preferences
MMI-20025166 March 2019
Configuration and Use Manual 129