Emerson Micro Motion 5700 - SD Card Full; Severe Two Phase Flow; Time Not Entered; Transmitter Software Update Failed

Cause
The transmitter's SD card has failed.
Recommended actions
1. Make sure that the SD card is firmly seated in the socket.
2. Contact customer service.
17.13.61 SD Card Full
Alert
Data Loss Possible
Cause
The transmitter's SD card is 90% full.
Recommended actions
Contact customer service.
17.13.62 Severe Two Phase Flow
Alert
Process Aberration
Cause
The transmitter has detected severe two-phase flow.
Recommended actions
Check your process conditions against the values reported by the device.
17.13.63 Time Not Entered
Alert
Configuration Error
Cause
The system time has not been entered. The system time is required for diagnostic logs.
Recommended actions
Set the system time.
17.13.64 Transmitter Software Update Failed
Cause
The transmitter software update failed.
Troubleshooting Configuration and Use Manual
March 2019 MMI-20025166
282 Micro Motion Model 5700 Transmitters with Configurable Outputs