Emerson Micro Motion 5700 Configuration And Use Manual

17.22 Check Frequency Output Mode ............................................................................................... 288
17.23 Check HART burst mode...........................................................................................................288
17.24 Check HART communications.................................................................................................. 288
17.25 Locate a device using the HART 7 Squawk feature.................................................................... 290
17.26 Check grounding......................................................................................................................291
17.27 Perform loop tests....................................................................................................................291
17.28 Check Lower Range Value and Upper Range Value ...................................................................297
17.29 Check mA Output Fault Action .................................................................................................297
17.30 Trim mA Output....................................................................................................................... 298
17.31 Check the pickoff voltage......................................................................................................... 299
17.32 Check power supply wiring.......................................................................................................300
17.33 Check for radio frequency interference (RFI).............................................................................300
17.34 Check sensor-to-transmitter wiring.......................................................................................... 301
17.35 Check the sensor coils.............................................................................................................. 301
17.36 Using sensor simulation for troubleshooting............................................................................ 303
17.37 Check the printing....................................................................................................................303
17.38 Check for two-phase flow (slug flow)........................................................................................304
17.39 Temperature measurement problems......................................................................................304
17.40 Velocity measurement problems..............................................................................................305
Appendix A Using the transmitter display..................................................................................... 309
A.1 Components of the transmitter display........................................................................................ 309
A.2 Access and use the display menus................................................................................................ 310
Appendix B Using ProLink III with the transmitter......................................................................... 315
B.1 Basic information about ProLink III ...............................................................................................315
B.2 Connect with ProLink III ............................................................................................................... 316
Appendix C Using a Field Communicator with the transmitter...................................................... 333
C.1 Basic information about the Field Communicator ........................................................................333
C.2 Connect with the Field Communicator ........................................................................................ 334
Appendix D Channel combinations................................................................................................337
D.1 Rules for channel combinations................................................................................................... 337
D.2 Valid combinations for channel configuration..............................................................................337
Appendix E Concentration measurement matrices, derived variables, and process variables........ 341
E.1 Standard matrices for the concentration measurement application............................................. 341
E.2 Derived variables and calculated process variables....................................................................... 342
Appendix F Environmental compliance.........................................................................................345
F.1 RoHS and WEEE............................................................................................................................ 345
Appendix G Example tickets..........................................................................................................347
G.1 Print examples............................................................................................................................. 347
Appendix H Software history (NAMUR recommendation NE53).....................................................351
Contents Configuration and Use Manual
March 2019 MMI-20025166
6 Micro Motion Model 5700 Transmitters with Configurable Outputs

Emerson Micro Motion 5700 Specifications

General

Brand	Emerson
Model	Micro Motion 5700
Category	Transmitter
Language	English