Epson RC620 CU - HDD Recovery Procedure (S;N 01;02-01001 or Later); Backing up EPSON RC+ Data

Maintenance 7. Recovering the HDD
RC620 Rev.8 203
(6) When the restoration is completed, the message below appears.
Press any key on the keyboard to reboot the RC620 controller.
7.2 HDD Recovery Procedure (S/N 01/02-01001 or later)
Recovery Step
Reference
1
Back up the current data
Maintenance
4.3 Backup
2
Back up the current EPSON
RC+ data
Maintenance
7.1.1
Backing up EPSON RC+
data
3
Windows recovery
Maintenance
7.1.2 Recovering Windows
4
Restore the EPSPN RC+ data
Maintenance
7.1.3 Restoring EPSON RC+ data
5
Restore the backup data
Maintenance
4.4 Restore
To recovery the HDD, prepare the following.
Item
Note
RC620 Recovery Disk
Attached to the controller.
PS/2 keyboard
When using USB keyboard.
PS/2 mouse
When using USB mouse.
USB DVD-ROM drive
When DVD drive is not installed.
- When recovering Windows, USB keyboard and USB mouse are not available. Make
sure to use PS/2 keyboard and PS/2 mouse.
- The recovery data is built in the RC620 controller HDD.
However, depending on the HDD status, the recovery work does not work. When you
cannot recover, replace the HDD.
7.2.1 Backing up EPSON RC+ data
(1) Exit EPSON RC+ if it is running.
(2) Copy the all files in the following folders in HDD to a USB memory or other memory
medium.
C:¥EpsonRC60¥Backup
C:¥EpsonRC60¥Calib
C:¥EpsonRC60¥Config
C:¥EpsonRC60¥Projects
C:¥EpsonRC60¥Status
Drive restore was successful. Please reboot your system.
Press any key to continue . . .

NOTE