Epson RC620 CU - Page 37

Setup & Operation 2. Part Names and Functions
RC620 Rev.8 21
*3 The 1
st
line displays “Task” and a task number in 3 figures, and “L” or “P” and an
execution line in 4 figures. In initial status, execution line of task number 1 is
displayed in three-digit.
Use Ton statement to change the displayed task number.
For details, refer to SPEL
+
Language Reference manual or Online Help.
The 2
nd
line displays “Tasks Running” or “Paused”.
However if the warning occurs, it displays the warning number. It displays the user
message when Print #28 specifies the message.
Particular Status Display
When particular status occurs, LCD displays the followings.
LCD
Status
Initialize Error 16
Controller startup failure *1
P-***
Controller startup mode
Controller startup failure
9999
Recovery Mode
Controller in Recovery mode
Refer to Maintenance 4. Backup and Restore.
9998
AC Power Off
AC power supply drop is detected and software shut down.
9997
Controller shutdown
Software shut down is specified from the EPSON RC+ 6.0
(software) or the SPEL
+
program.
*1 When the Initialize Error occurs, reboot the Controller. If the Initialize Error is
displayed again after the Controller is rebooted, please contact the supplier of your
region.