For mono output:
Delay Mix = 0%, output 1 will have only delay A’s contribution.
Delay Mix = 50%, output 1 has an equal amount of delay A and delay B.
Delay Mix = 100%, output 1 will have only delay B’s contribution.
For stereo output:
Delay Mix = 0%, both outputs will have only delay A’s contribution.
Delay Mix = 50%, delay A goes to output 1 only and delay B goes to output 2 only.
Delay Mix = 100%, both outputs will have only Delay B’s contribution.
Delay A: Sets delay time from 0 to 3000 ms (milliseconds). With Tempo Sync OFF, delay is
displayed in ms. With Tempo Sync ON, delay can be sync’d to the tempo and is displayed as a
rhythmic sub-division of the tempo beat value from No Delay to a whole note in common note
increments.
Delay B: Same as A.
Feedback A: Controls level of Feedback A, the number of repeats.
Feedback B: Same as A.
X-Fade: When delays change, performs a crossfade function to prevent abrupt changes that could
result in glitching or clicking. X-Fade sets the speed of the crossfade. Small values result in rapid
crossfades, larger values more gradual crossfades. Crossfade rates vary from 2 ms to 200 ms.
Modulation Depth: Selects the amount of delay modulation (0 = Off, 10 = Max).
Modulation Speed: Sets the delay modulation rate (0 - 5 Hz).
Filter: A low pass/high pass filter variable from -100 (max high pass) to 0 (no filtering) to 100 (max
low pass) to change the tone of your delay repeats.
Performance Parameters
Repeat: A momentary or latching parameter that sets the feedback to the highest value.
Factory Presets
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
