Eventide Harmonizer H90 - MultiTap

Modulation Wave Shape: Selects the modulation wave shape. There are two choices for each wave
shape. The single waveforms modulate the two delays in phase and the double waveforms modulate
the two delays out of phase.
Modulation Depth: Selects the amount of delay modulation (0 = Off, 20 = Max).
Modulation Speed: Sets the delay modulation rate (0 - 5 Hz).
Filter: A low pass/high cut filter variable from -100 (max low cut) to 0 (no filtering) to 100 (max high
cut).
Performance Parameters
Repeat: A momentary or latching parameter that sets the feedback to the highest value.
Factory Presets
1.. And 2 Mod
ChorusPhase No Delay
Creepy
Every Lead You Fake
Funk Echo
LazyPhasy
Lost Lunch
Pedal Pitch
PhaserEcho1
PhaserEcho2
MultiTap
10 delay taps with controls for delay time, diffusion, tap levels, and tap spacing.
Mix: wet/dry mixer, 100% is all wet signal.
Delay Mix: Controls the relative level of Delay A and Delay B. Delay Mix’s mixing behavior depends
on whether you’re using mono or stereo outputs.
For mono output:
Delay Mix = 0%, output 1 will have only delay A’s contribution.
Delay Mix = 50%, output 1 has an equal amount of delay A and delay B.
Delay Mix = 100%, output 1 will have only delay B’s contribution.
For stereo output:
Delay Mix = 0%, both outputs will have only delay A’s contribution.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
140
11. ALGORITHM GUIDE