Eventide Harmonizer H90 - Page 141

Delay Mix = 50%, delay A goes to output 1 only and delay B goes to output 2 only.
Delay Mix = 100%, both outputs will have only Delay B’s contribution.
Delay A: Sets delay time from 0 to 3000 ms (milliseconds). With Tempo Sync OFF, delay is
displayed in ms. With Tempo Sync ON, delay can be sync’d to the tempo and is displayed as a
rhythmic sub-division of the tempo beat value from No Delay to a whole note in common note
increments.
Delay B: Same as A.
Feedback A: Controls level of Feedback A, the number of repeats.
Feedback B: Same as A.
Slur: Controls the diffusion of the repeats from discrete to slurred.
Taper: Sets the relative level (taper) of the taps. With Taper at -10, the 1st tap is the quietest and the
last tap loudest. With Taper at 0, all taps are equally loud. With Taper at 10, the 1st tap is loudest
and the last tap quietest.
Spread: Sets the spacing between taps from 0 (spacing increases) to 5 (taps are equally spaced) to
10 (spacing between taps decreases).
Filter: Tone control that reduces high frequencies to darken the ambient sounds that you create.
Performance Parameters
Repeat: A momentary or latching parameter that sets the feedback to the highest value.
Factory Presets
500 Seater
Airplane Hanger
Ambient Multi
AutoMarch
Big SwellPad1
EmptySpace
Galloper Multi
Ghost Town
King’s Missile
Multi Hall
Multi WetLive
Strummer
Strummer2
Tapomatic
Tapper
Worms
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
141