Eventide Harmonizer H90 - Looper; 60 seconds of stereo recording

Looper
60 seconds of stereo recording at full audio quality and up to 480 seconds at reduced audio quality.
Salient features: record in seconds or beats, variable speed scrubbing during playback and dubbing
(including reverse playback and dubbing), seamless dubbing, real-time adjustment of the loop starting
point and loop length, full featured MIDI Clock sync, and the all-new 1-Button Looper.
Mix: Mix control between the Dry audio input and Looper playback.
Loop Max-Length:
When the Loop is Empty, sets the Maximum allowed Loop Length. Note that audio recording quality
is degraded at slower recording speeds (1/2X and 1/4X). The maximum loop length is determined
by the setting of the Speed parameter as follows:
Speed (+/-) 2X, Max Loop Length 60 sec
Speed (+/-) 1X, Max Loop Length 120 sec
Speed (+/-) 1/2X, Max Loop Length 240 sec
Speed (+/-) 1/4X, Max Loop Length 480 sec
Select (-) negative speeds to automatically starting playback in reverse after recording a new loop.
When the Loop contains audio, the Max-Length parameter cannot be adjusted.
 Note
With Tempo Mode On, the range of the Max-Length parameter depends on the H90’s Tempo BPM
value. Lower BPM values will not fill up the entire parameter range.
Loop Play-Start Point: When a Loop is in memory, this sets the Loop Start Point from 0 ms (or beat 1
for Tempo Sync ON) to Loop Length. Loop Play-Start Point defaults to 0 (or beat 1 for Tempo Sync
ON) at the beginning of a new loop. Note that Catchup is always enabled to prevent the Start point
from changing abruptly. When the Loop is Empty, this parameter is disabled.
Loop Play-Length:
When a Loop is in memory, this sets the Loop Play-Length for playback that begins at the Loop Start
Point. In other words, if a 12 second Loop is recorded and the Loop Start Point is set to 2 seconds
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
157