Eventide Harmonizer H90 - 3.4.1. Wet;Dry Examples

3.4.1. Wet/Dry Examples
Series
Using Series routing, if the tap position of the dry amp is pre-Preset A and B, this gives you an unprocessed
signal in the dry amp, and a signal that is processed by both Presets in the wet amp.
Set the Insert Mix to 0% and try using a combination of modulation and reverb in the wet amp, such as Even-
Vibe in series with SP2016 Reverb.
Fig. 3.7 The tap position of the dry amp is pre-Preset A in Series
Parallel
Using Parallel routing, if the tap position of the dry amp is post-Preset A, this allows you to process the signal
sent to your dry amp with Preset A, while Preset B is sent to the wet amp in a parallel path.
Set the Insert Mix to 100% and try using WeedWacker in Preset A for the dry amp, and Head Space in Preset
B for the wet amp. Since you are using a parallel path, WeedWacker will only process the audio going into the
dry amp, while your guitar’s clean signal will be processed by Head Space and sent the wet amp.
Fig. 3.8 The tap position of the dry amp is post-Preset A in Parallel
28
3. SETUP