Performance Parameters
FLEX: Doubles the pitch shift amount of both voices.
Factory Presets
BassChorus(es)
Bottomless Drop
Chorus Room
DarkEchoes
Elevator Delays
H3000 MicroPitch
NiceChorus
Slap My Echo
Spacey Springs
Thick
VibraChorus
Octaver
Octavers traditionally use analog techniques to track the pitch of the input audio signal and synthesize a
signal whose musical tone is an octave lower than the original. Octaver creates a pair of sub-harmonics,
one an octave below the note that you’re playing and the other two octaves below. It also adds an Octave
Fuzz generator. The sub-harmonics can be filtered and the filters modulated by the input audio level.
Note: Octaver is a parallel (dual mono) rather than stereo effect.
Mix: Wet/dry mixer, 100% is all wet signal.
Sub-Harmonic Mix: Controls mix of 1st and 2nd sub-harmonics (A and B). Note that Inputs 1 and
Inputs 2 are not mixed.
Filter Center Frequency A: Controls the center frequency of the resonant filter for A.
Filter Center Frequency B: Controls the center frequency of the resonant filter for B.
Filter Resonance A: Controls filter resonance for A. Note: After adjusting the filter’s center
frequency and resonance, you may want to try modulating the filter.
Filter Resonance B: Controls filter resonance for B.
Envelope Filter Shift: Octaver allows your playing to vary the center frequency of the filters. This
control adjusts the degree to which the input signal’s envelop shifts the filter’s center frequency.
Envelope Sensitivity: Controls the sensitivity of the frequency sweeps to the input signal level.
Distortion: Controls the amount of distortion (fuzz).
Octave-Fuzz Mix: Controls the mix of octaves and fuzz.
Factory Presets
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
