Bass Voweler Growl
Classic Octaver
Crab Bass
Drty Vocals
Massivuzz
NazztyBass
OctoFuzzver
ThroatyBass
WahElectronique
PitchFlex
PitchFlex is designed to be used ‘live’ with either an Expression Pedal, the on board HotKnob, or the Flex
switch. Using the Heel and Toe controls you can set the pitch shift of two voices at each end of travel of
the Expression Pedal. Turning these controls ‘OFF’ results in no pitch change. The other controls allow
you to tailor the ‘sweep’ by controlling its speed and shape.
Mix: Wet/dry mixer, 100% is all wet signal.
Pitch Mix: Controls the ratio of the level of Pitch A to Pitch B.
Manual Shift: Sweeps the pitch from the ‘heel’ to ‘toe’ value. Map an expression pedal to this
parameter and adjust it to perform the sweep.
Heel A/B: Sets pitch shift of the voice in the heel position. When ‘OFF’ is selected, the voice is
muted at the heel position and the pitch is set to unison.
Toe A/B: Sets pitch shift of the voice in the toe position. When ‘OFF’ is selected, the A pitch shifter
is disabled at the toe position and toe is treated as unison.
Heel-to-toe glissando: This parameter is for use when using the Flex performance parameter, or an
Auxiliary Switch to control the pitch change effect for voices A and B. Sets the time to move from
‘heel’ to ‘toe’. With Tempo Sync ON the maximum is ½ note.
Toe-to-heel glissando: Same as above, but set the time to move from ‘toe’ to ‘heel’.
Glissando Shape: Controls the ‘shape’ that the pitch modulation follows when using the Flex Switch.
If set to Negative values, the pitch goes slowly towards ‘toe’ and quickly transitions to ‘heel’, Positive
is the other way around, and 0 means the pitch shifts up and down linearly.
Low Pass Filter: A low pass filter to ‘darken’ the effect.
Performance Parameters
Flex: Sweep the pitch shift from ‘toe’ to ‘heel’ position.
Factory Presets
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE