Performance Parameters
Retrigger: Retriggers the primary and secondary modulation LFOs to the beginning of their cycles. Useful
for re-syncing during playback, or creative effects.
Speed / Brake: The Brake engages while this switch is pressed. Short-press to toggle between Fast and
Slow. Long-press to engage Brake.
Fast / Slow: Press to toggle between Fast and Slow, which slows the primary and secondary LFOs by a
predetermined factor. The Brake does not engage while this switch is pressed.
Brake (M): Slows the LFOs at a constant rate and pauses the LFOs until the switch is released.
Factory Presets
Bass Auto Wah
BubblyFilter
HyperWah
Jupiter Reacts
Nervous Filter
TremModFilter
WateryFilter Dark
WateryFilterBright
Phaser
Phaser is an effect created by a series of all pass filters (phase shifters). When the output of the filters is
mixed with the dry signal sharp notches are created in the frequency spectrum of the output; by
modulating the center frequencies of the filters the notches move giving a sense of motion to the effect.
Intensity: Effect level.
Type:
Positive: Mixes the feed-forward and feedback signals, non-inverted.
Negative: Mixes the feed-forward and feedback signals, inverted.
Feedback: No feed-forward signal; Feedback only.
Bi-phase: Based on the topology of the
Mu-Tron Bi-Phase.
PhaseX0: A phase 90 clone (but it also does phase 180 and some others if you check Stages).
Depth: Sets the modulation sweep range from narrow to wide.
Speed / Sensitivity: Sets the modulation sweep rate. Speed becomes Sensitivity when Shape is set
to Envelope or ADSR.
Shape: Selects the waveform, or source, of the modulation. The choices are:
Sine
Triangle
Peak
Random
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
