Eventide Harmonizer H90 - Wormhole

ABitShakey
AmeTremVerb1
AmeTremVerb2
Broken Glitch
Horror Show
Splitter Verb
TremoloVerb
Wormhole
Mega-sized, tilting reverb. How deep are you willing to go?
Mix: Wet/dry mixer, 0 is fully dry, 100 is fully wet.
Length: Wormhole distance in light years. Controls the decay time of the reverb. Internally tapered
from 0 l.y. (shortest decay, 3s) to 100 l.y. (longest decay, 1000s). (0 to 100 l.y. or 30.67 parsecs).
Diameter: Width of the interstellar Wormhole. Controls the size of the reverb. A Diameter of 0 is
tight enough to pull the ears off a gundark. A Diameter of 100 will fit Executor-class Super Star
Destroyers eight abreast.
Lo Decay: Decay rate of the low frequency content of the reverb. 0 is quickest decay. 100 is
slowest decay.
Hi Decay: Decay rate out of the high frequency content of the reverb. 0 is quickest decay. 100 is
slowest decay.
Entry Field: Entrance characteristics to the Wormhole. Controls early reflections and diffusion in
the reverb. 0 is a rougher entrance to the WormHole (less diffuse, noticeable early reflections).
100 is a smoother entrance to the Wormhole (more diffuse, less noticeable early reflections).
Pre Delay: Delay added before Wormhole entrance. (0 t0 2000ms)
Stability: Wormhole stability across time. Controls modulation depth of the reverb. 0% is the least
stable Wormhole with large pitch variations happening to the reverb through time (max
modulation/most unstable). 100% is a stable Wormhole with no reverb pitch variations through
time (no modulation).
Stability Rate: Movement speed of an unstable Wormhole. Controls modulation rate of the reverb.
Range is from 0 (slowest rate) to 100 (fastest modulation rate). Use in conjunction with the Stability
control.
Warp Acceleration: How long it takes to traverse the wormhole and reach the top warp speed set
by the Warp Factor control. Units are in total time to traverse the worm hole and lower values
accelerate faster. Controls the rate of change of the reverb delay lines. (1.0 to 10s)
Warp Factor: Top warp speed desired through the worm hole. Higher Factors manifest as a higher
final pitch changes. Warp Factor 10.00 theoretically highest possible speed. Controls the amount of
change of the delay lines. (5 to 10s)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
237