Determines the H90’s routing behavior:
Auto: The H90’s algorithms will automatically determine the correct mono/stereo and summing behavior
based off of what jacks are physically connected.
Mono input/output will result in all algorithms processing in mono. Use I/O 1, I/O 2 is not supported for
mono operation.
Mono input/Stereo output will result in all algorithms processing in stereo. Use input 1 for this setup,
input 2 is not supported for a mono/stereo configuration.
Stereo input/output will result in all algorithms processing in stereo.
Stereo inputs/Mono output will result in a mono summed output on output 1. Use output 1 for this
setup, output 2 is not supported for stereo/mono summing.
Mono inserts will sum audio to mono. Algorithms will process in stereo when using mono inserts with
mono/stereo or full stereo configurations. If a mono insert is at the end of your signal path the output
will be summed to mono.
All of the above information also applies to I/O 3-4 for Path 2 when using Dual Mode. For example, use
input 3 and outputs 3-4 for a mono/stereo setup. I/O 4 is not supported for mono or stereo/mono
configurations.
Force Mono: The H90’s dry path and all of the algorithm processing will be summed to mono, regardless of
what physical jacks are connected. Outputs 1-2 will be a duplicate copy of the mono summed signal. This is
useful if you have your H90 connected in stereo on your pedal board or patch bay and you do not want to
disconnect the input/output jacks for mono operation.
7.3. Bluetooth
Note
H90 software version 1.7.5+ is required to enable Bluetooth functionality.
The H90 can pair and connect to your Mac, iPad, and iOS device via Bluetooth. This allows you to connect
to H90 Control (Mac/iPad only) or send MIDI messages via a DAW or 3rd party MIDI control app.
•
•
•
•
•
•
•
•
7. SYSTEM MENU
To Next Page
Loading...
