Even-Vibe
A faithful emulation of the classic Shin-ei Uni-Vibe™ in stereo! Imagine owning two Uni-Vibes and being
able to control their LFOs for a true stereo effect, plus an envelope follower as an added bonus. A clunky
foot controller is not required or included, but feel free to map your expression pedal to Speed for
maximum vibes. This is not your grandad’s Uni-Vibe!
Mix: Controls the mix between the unprocessed input and the modulated output. Set to 50% for a
Uni-Vibe in chorus mode. Set to 100% for Uni-Vibe in vibrato mode.
Speed: Determines the rate of the modulation. Tempo Sync off, Hertz. On, subdivisions. Like a
classic Uni-Vibe, Speed will also subtly effect the intensity of the modulation. Don’t overthink it.
Intensity: Adjusts the depth of the modulation.
Width: Adjusts the stereo width of the output.
Env Speed: Adjusts how much the envelope controls the rate of the modulation. Negative values
will result in slower modulation while the envelope is open, positive values will result in faster
modulation.
Env Inten: Adjusts how much the envelope controls the depth of the modulation. Negative values
will result in less intensity of the modulation while the envelope is open, positive values will result
in more intensity.
Softclip: Adjusts the amount of gentle transistor soft clipping.
Performance Parameters
Retrigger: Retriggers the LFO to the beginning of the cycle. Useful for re-syncing during playback, or
creative effects.
Factory Presets
Air Bubbles
Ebb & Flow
Even-Vibe
Indigo Fog
Slowly Drifting
Widevibe
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
