Ducking Ratio: Sets the ducking ratio or the degree to which the delay is attenuated.
Threshold: Sets the ducking threshold - the audio amplitude - at which ducking kicks in (-36 dB to
-66 dB).
Release Time: Sets the release time from 500 to 10 ms. With the release time set to short values,
the delay will kick in quickly when you stop playing. With the release time set to longer values, the
delay will stay ducked for a while. Longer release times are useful when you’re playing a riff and
don’t want the delay to kick in between notes.
Filter: A low pass/high pass filter variable from -100 (max high pass) to 0 (no filtering) to 100 (max
low pass) to change the tone of your delay repeats.
Performance Parameters
Repeat: A momentary or latching parameter that sets the feedback to the highest value.
Factory Presets
ComfNumbSolo
Country Compressor
Country Compressor
DontLeaveMe
ThinIce
Volume Swell Helper
Filter Pong
The dual delays ping pong between the outputs with filter effects added for good measure.
Mix: wet/dry mixer, 100% is all wet signal.
Delay Mix: Controls the relative level of Delay A and Delay B. Delay Mix’s mixing behavior depends
on whether you’re using mono or stereo outputs.
For mono output:
Delay Mix = 0%, output 1 will have only delay A’s contribution.
Delay Mix = 50%, output 1 has an equal amount of delay A and delay B.
Delay Mix = 100%, output 1 will have only delay B’s contribution.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
