For stereo output:
Delay Mix = 0%, both outputs will have only delay A’s contribution.
Delay Mix = 50%, delay A goes to output 1 only and delay B goes to output 2 only.
Delay Mix = 100%, both outputs will have only Delay B’s contribution.
Delay A: Sets delay time for Delay A output from 0 to 3000 ms. With Tempo Sync OFF, delay is
displayed in ms. With Tempo Sync ON, delay can be sync’d to the tempo and is displayed as a
rhythmic sub-division of the tempo beat value - changing this from 0 to a whole note in common
note increments.
Delay B: Same as A.
Feedback A: Controls level of Feedback A, the number of repeats. The FilterPong Effect is created
by cross connecting the feedback paths of the twin delays. As a result, only a single feedback
control is needed.
Slur: Controls the diffusion of the repeats. With low diffusion the repeats are discrete. Increasing
diffusion slurs the repeats.
Modulation Wave Shape: Selects the shape of the filter modulation. The options are:
Sine
Triangle
Square
Modulation Depth: Sets the filters’ amount of frequency modulation.
Modulation Speed: Speed multiplier for filter modulation.
Filter: Controls the mix of dry/filtered signal input to ping-pong delay.
Performance Parameters
Repeat: A momentary or latching parameter that sets the feedback to the highest value.
Factory Presets
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
