Tempo Sync Footswitch Quantization
MIDI Clock is made up of a series 24 “ticks” per beat. Tempo Sync quantizes many of the Footswitch
actions either to the next MIDI beat or the next MIDI tick. The quantization action of the Footswitches for
each Looper State is as follows:
Empty:
Record: Starting a new recording syncs to the next beat ONLY if synced to an external MIDI clock
source and AFTER having received a MIDI Start command. Otherwise, this begins recording on the
next tick.
Play: No action.
Stop: Only used for tap tempo.
Recording:
Record: Record to Dub transition quantizes to the next beat.
Play: Record to Play transition quantizes to the next beat.
Stop: End recording and stop, quantized to the next beat.
Dubbing:
Record Dubbing in/out doesn’t do any footswitch action quantization.
Play: End Dubbing and Start Playing from Loop Start. This action quantizes to the next tick.
Stop: End Dubbing and Stop Playing. This action quantizes to the next beat.
Playing:
Record: Start Dubbing, no footswitch quantization.
Play: Start Playing from Loop Start. This action quantizes to the next tick.
Stop: Stop Playing. This action quantizes to the next beat.
Stopped:
Record: Starting a new recording quantizes to the next beat ONLY if in MIDICLK Slave mode
AFTER having received a MIDI Start command. Otherwise, this begins recording on the next tick.
Play: Start Playing from Loop Start. This action quantizes to the next tick.
Stop: No action.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
