Performance Parameters
1-Button Looper: The 1-button looper allows you to easily control the transport of the looper using a single
Footswitch.
Press once to begin recording a loop. Press again to finish recording and play the loop.
While the loop is playing:
Press the Footswitch to toggle overdub on/off.
Press-and-hold the Footswitch to undo/redo.
Double-press the Footswitch to stop playback of the loop.
While the loop is stopped, press-and-hold the Footswitch to empty the loop.
The following performance parameters can only control a single aspect of the looper’s transport. It is
recommended to map these to an external aux switch or MIDI controller.
Record: Press the Footswitch to start recording a loop.
Play: Press the Footswitch to play a loop that has been recorded. The Playmode parameter will determine
how this works.
Stop: Press the Footswitch to stop playback of the loop.
Empty: Press the Footswitch to empty the loop.
Undo/Redo: Press the Footswitch to undo the last overdub. Press it again to redo.
Factory Presets
16 Beat Auto Loop
16 Beat Reverse Start
48 Beat Basic Looper
8 Beat Punch
8 Beat Punch Replace
Basic Looper
Dub Decay Looper
LoFi 16 Beat
Long Basic Looper
Thin Loop
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
