then the high voice will rise, following by a rising mid voice, and then a rising low voice. This creates
a simultaneous ascending while descending sort of effect. The choices are:
L-M-H
L-H-M
M-L-H
M-H-L
H-L-M
H-M-L
Auto Eq: An Eq for the pitch shifted voices. A default setting of 10 is recommended.
The following controls are available for all three voices:
Gain: A gain control for the specific voice.
Feedback: A feedback control for the specific voice.
Feed Tap: Feedback tap. When set to Total, each arp will complete a full cycle before feeding back.
Sequence 1 and Sequence 2 cause the feedback to happen before the arpeggio is complete leading
to interesting repeating patterns. Random uses a random feedback tap. The options are:
Total
Sequence 1
Sequence 2
Random
Spread: Controls the stereo spread of the voices. When set to -1 the Low voice is panned hard left,
the mid voice is panned center, and the high voice is panned hard right. When set to +1 this is
reversed. Intermediate values morph between these two extremes.
Slew Time: A slew on the Shift control. A large value will cause changes to the Shift parameter to
glissando.
Performance Parameters
Freeze (latching): Freezes the “High” and “Low” pitch shifted voices, the “Mid” voice (which is not pitch
shifted) is not frozen.
Shift (M): Moves the current value of the shift knob 1 position clockwise, wrapping if necessary.
-1oct +1oct shifts to -P4 +P5
-P4 +P5 shifts to -P5 +P4
-P5 +P4 shifts to -1 +1oct
+1oct +2oct shifts to +P5 +P12
+P5 +P12 shifts to +P4 +P11
+P4 +P11 shifts to +1oct +2oct
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
