Depth: Assigns LFO to modulate Oscillator Depth.
Attack: Gate Attack speed from 0 to 3000ms. When the Gate Sustain/Range knob is set to OFF,
Attack knob has no effect.
Decay: Gate Decay speed from 0 to 3000ms. When the Gate Sustain/Range knob is set to OFF,
Decay knob has no effect.
Gate: Assigns gate destination and controls amount of either Sustain or Range of the Gate. Knob has
four ranges. Gate Sustain level occurs after both Attack and Decay of the Gate (There is no release
in the Gate). Gate Range (for Pitch as destination) is how far from 0 pitch modulation is allowed to go
at the end of Gate attack.
Off: Disconnects the Gate. Attack and Decay control will have no affect on signal.
Cutoff: Assigns the Gate to modulate Cutoff frequency.
Volume: Assigns Gate to modulate wet output level.
Pitch: Assigns Gate to modulate pitch Range +/-3600 cents. Returns to 0 modulation after Gate
Decay.
Depth: Assigns Gate to modulate Oscillator Depth.
Envelope: This Envelope is triggered and drawn by dynamics of input level. This parameter assigns
Envelope destination and controls amount of modulation. It has four ranges, each 0 to 100. Each
range assigns the Envelope to a different destination for modulation.
Cutoff: Assigns the Envelope to modulate cutoff frequency.
Volume: Assigns the Envelope to modulate wet output level.
Pitch: Assigns the Envelope to modulate pitch.
Depth: Assigns Envelope to modulate Oscillator Depth.
Performance Parameters
Retrigger: Retriggers the LFO to the beginning of the cycle. Useful for re-syncing during playback, or
creative effects.
Factory Presets
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
