62
MB1 User Manual
© 2016 Expert Electronics
MAIN SCREEN DESCRIPTION
5.2.7 MIC/CW SETTINGS
Press and hold the MIC button on the front panel of the transceiver to open/close the local
panel.
MIC1 - MIC 1 button.
Press the MIC1 button to choose corresponding microphone.
MIC1 GAIN - Microphone input gain control.
Set the required gain level of the microphone input. Control sets the max microphone's AGC
gain, while the microphone AGC is active.
MIC2 - MIC 2 button.
Press the MIC2 button to choose corresponding microphone.
MIC2 GAIN - Microphone input gain control.
Set the required gain level of the microphone input. Control sets the max microphone's AGC
gain, while the microphone AGC is active.
MIC PC - PC's sound card MIC.
Press the MIC PC button to choose PC's microphone.
MIC PC GAIN - Microphone input gain control.
Set the required gain level of the microphone input. Control sets the max microphone's AGC
gain, while the microphone AGC is active.
BREAK IN - CW VOX mode.
Press the BREAK IN button to enable this mode - transceiver will automatically turn to the TX
mode by the press on the CW keyer.
IAMBIC - Automatic dots and dashes generation.
Press the IAMBIC button to enable auto generation of the CW signal.
If the IAMBIC mode is off, while you press the CW keyer it will generate tone signal with PITCH
frequency.
REV PADDLE - Dots and dashes reverse switch.
Press the REV PADDLE button to switch dots and dashes in reverse order on your CW keyer.
BREAK IN DELAY(ms) - Timing control, to keep the transceiver in the TX mode.
Set the required time for the transceiver to hold in the TX mode, after you let go of the CW
keyer.
To Next Page
Loading...
