92
MB1 User Manual
© 2016 Expert Electronics
MAIN SCREEN DESCRIPTION
Note:
(
Via the OmniRig software could be send a limited amount of control commands.
Available control commands:
–
Set VFO frequency, if no VFOB in the CAT protocol;
–
Set VFO A frequency;
–
Set VFO B frequency;
–
Enable receiver's RIT offset;
–
Set RIT offset;
–
Reset RIT offset;
–
Enable transceiver's XIT offset;
–
Set mode type;
–
Enable SPLIT.
5.3.4.1 RX1 receiver
RX1 tab contains a САТ-system settings and control of the transceiver's PTT command via
COM-ports for the RX1 receiver.
· Protocol - Exchange protocol menu with external devices.
Select the required exchange protocol with external devices or software from the list.
To Next Page
Loading...
