Extron electronics SMP 351 - Clearing Passwords

2. Enter the same password into the Confirm Password: field directly below the
Administrator Password field. Once a password is entered, the fields in the
Login ID: user panel are accessible.
Figure 70. Password Panel Closeup
3. If no user password is set, click Save in the upper right of the Password panel. To set
a user password, complete steps 4 through 6.
4. To set a user level password, type a desired password into the UserPassword: field
in the Login ID: panel.
5. Type the same password into the Confirm Password: field directly below the
UserPassword field.
6. Click Save. Both the administrator and user passwords are saved.
NOTE: If only an administrator password is set, only administrators are able to log in
to the SMP351 Web pages. Users have no access.
To allow user access to a password-protected unit, set both an adminstrator
password and a user password, and users must log in using the user password.
Clearing Passwords
To remove (clear) a password, click Clear corresponding to the administrator or user
password to remove.
NOTE: When the administrator password is cleared, the user password is also cleared.
SMP351 • Web-Based User Interface 109