Extron electronics SMP 351 - Set the Startup State for the Application

Set the Startup State for the Application
If desired, specify whether to run the application when the SMP starts up or upon reboot.
You must do this within the SMP351 embedded Web pages, in the Configuration >
Advanced Features > Apps panel, not within the application.
To set the startup state for an application:
1. Click in the Startup State column of the Apps panel to access the drop-down list.
2. Select Enabled (default, run the app upon unit startup) or Disabled (do not run the
app upon startup).
SMP351 • Flex I/O Applications 155