5. By default, the SMP351 applies only the first action (action 1). To apply action 2 or 3,
select (check) the check box adjacent to each desired action.
6. Click Apply to save the configuration.
NOTE: An error is returned if attempting to save a monitor without at least one
condition and one action.
7. To have the SMP monitor an additional combination of conditions, click the + tab. A
new Monitor n tab is created.
8. Click the Monitor n tab. The Monitor n page opens.
9. Configure the new monitor as described in steps 1-6.
10. If desired, rename the monitor:
a. Double-click on the Monitor n tab. A field replaces the tab label.
b. Edit or type in text as desired.
c. Click outside the tab. The new text replaces the default text on the tab. Only about
11 characters appear on the tab.
11. If desired, create additional monitors for a total of up to 16 monitors.
12. When you are finished creating monitors, click Close. In the Save Changes? dialog
box, click Yes to save and apply the monitors and configurations to the unit and to
close the pop-up box.
NOTE: Any monitor except monitor 1 can be deleted by clicking the "x" in the upper
right corner of a monitor tab, then clicking Yes in the Delete Monitor? dialog box.
If you do not want to use monitor 1, you can stop the application from running (Exit
the application). In the Conguration > Advanced Features > Apps panel select
Stop from the Run State drop-down list for that application, (see image below).
SMP351 • Flex I/O Applications 154
To Next Page
Loading...
