Image Settings
The controls within the Image Settings page within the Configuration tab provides
a way to configure video input sampling and sizing, set up overscanning of SMPTE input
signals, and adjust picture controls (brightness, contrast, and similar). This page also allows
you to save or recall input and user presets.
A user must be logged in as an administrator to see or change these settings. This page is
divided into seven panels:
• Input Config – select the input to be configured.
• Picture Controls – Alter the quality of the image by changing brightness, contrast,
color, and tint.
• Signal Sampling – Configure the size, location, and aspect ratio of the currently
selected input or select Auto-Image, Auto-Image & Fill, and Auto-Image &
Follow.
• Overscan – Set the amount (0, 2.5%, or 5%) of picture enlargement applied to each
video signal type for any SMPTE standard input.
• Input Presets – Save or recall preset combinations of signal type, signal sampling, and
picture controls.
• User Presets – Save or recall sets of picture controls.
• SDI Settings – Set the quantization range for SDI signals from input 5
(SMP3513G-SDI only).
To open this page, click the Configuration tab at the top of the SMP351 embedded
Web pages and then click the Image Settings tab on the second tier of tabs.
The Image Settings page opens.
Figure 54. Image Settings Page
SMP351 • Web-Based User Interface 82
To Next Page
Loading...
Need help?
General
