Flexim FLUXUS G704 - 15.4 Settings of the Standard Conditions for the Gas Measurement

144 UMG70XV3-4EN 12.01.2009
15 Settings
15.4 Settings of the Standard Conditions for the Gas Measurement
15.5 Setting the Contrast
Select SPECIAL FUNCTION\SYSTEM SETTINGS\GAS-
MEASURING.
This display is indicated only if in SPECIAL FUNC-
TION\SYSTEM SETTINGS\MEASURING the gas measur-
ing has been activated.
Enter the pressure for the local standard conditions.
Enter the temperature for the local standard conditions.
Select SPECIAL FUNCTION\SYSTEM SETTINGS\MIS-
CELLANEOUS to set the contrast of the display of the flow-
meter. Press ENTER.
The contrast of the display will be adjusted with the follow-
ing keys:
increases the contrast
decreases the contrast
= min. contrast
= medium contrast
= max. contrast
Note!
The display will be reset to medium contrast after a cold start.
SYSTEM settings 
Gas-Measuring
Normal pressure
1.01325 bar
Normal temper.
0.0 C
SYSTEM settings 
Miscellaneous
SETUP DISPLAY
 CONTRAST 
+ O
-
O
OFF
O
ON
O