126 UMG70XV3-4EN 12.01.2009
13 Storing and Output of Measured Values
13.3 Delete the Measured Values
Select the program branch SPECIAL FUNCTION. Press ENTER.
13.4 Settings for the Data Memory
Select SPECIAL FUNCTION\SYSTEM SETTINGS\STORING. It contains the following
menu items:
• ring buffer
• sample mode
• storing of the totalizer values
• storing of the signal amplitude
• storing of the sound velocity
• storing of the concentration
• acoustic signal during storing
13.4.1 Ring Buffer
The setting of RINGBUFFER has influence on the storing of measured values as soon as
the data memory is full:
Select the serial interface for the offline output.
This display will be indicated only if the flowmeter has
an RS485 interface.
Select the list item DELETE MEAS.VAL. Press ENTER.
Select YES or NO. Press ENTER.
If ON is selected, the data memory will be halved. The old-
est measured values will be overwritten.
If OFF is selected, storing of measured values will be
stopped.
Press ENTER.
Send Offline via
RS232 >RS485<
Special Function
Delete Meas.Val.