UMG70XV3-4EN 12.01.2009 79
9 Start-up
9.4 Language Selection
The flowmeter can be operated in the languages listed below. The language can be se-
lected with the following HotCodes:
Depending on the technical data of the flowmeter, some of the languages might not be
implemented.
When the last digit is entered, the main menu will be displayed in the selected language.
The selected language remains activated after switching the flowmeter off and on again.
9.5 Operation State Indication (G709)
The operation state is indicated by 2 LEDs.
9.6 Interruption of the Power Supply
All current measuring parameters will be stored in a non-volatile cold start resistant EP-
ROM as soon as the measurement begins. The operation of the flowmeter will be inter-
rupted if the power supply fails. All input data remain saved..
The stopped measurement will be continued. All selected output options are still active.
The measurement is not continued after return of the power supply if a cold start was
performed.
Tabelle 9.1: Language HotCodes
909031 Dutch
909033 French
909034 Spanish
909044 English
909049 German
Hinweis! After initialization of the flowmeter the default language will be set
(key BRK and C when switching on).
Table 9.2: Operation state indication (LED SIGNAL)
LED off flowmeter offline
LED lights green signal quality of measuring channel sufficient for measurement
LED lights red signal quality of measuring channel sufficient for measurement
Table 9.3: Operation state indication (LED READY)
LED off no measurement
LED lights yellow measurement
LED flashes yellow before a HotCode can be entered, key C has to be pressed
After return of the power supply, the serial number will be
displayed for a few seconds.
FLEXIM FLUXUS
G70X-XXXXXXXX
To Next Page
Loading...
Need help?
General
