Flexim FLUXUS G704 - Selection of the Temperature Probe (FLUXUS G704); Linking Other Inputs to the Measuring Channels

UMG70XV3-4EN 12.01.2009 149
17 Inputs
Select the list items for T-FLUID/OUTLET, T(3) and T(4) of measuring channel A and
the other activated channels accordingly. Press ENTER after each input.
17.2 Selection of the Temperature Probe (FLUXUS G704)
If necessary, select the temperature probe for input T2, T3 and T4 accordingly.
17.3 Linking Other Inputs to the Measuring Channels
Select the list items for EXT. INPUT(2)...(4) of measuring channel A and the other
activated channels accordingly.
Select the temperature input to be linked to measuring
channel A as supply temperature.
Select the list item FIXED INPUT VALUE if the tempera-
ture is entered manually before the measurement.
Select the list item NO MEASURING if a supply temperature
is not to be linked to measuring channel A.
Press ENTER.
Note! The configuration of a measuring channel will be stored when the
next channel is selected. The configuration dialog of a channel has to
be finished to store the changes.
Select SPECIAL FUNCTION\SYSTEM SETTINGS\PROC.
INPUTS. Press ENTER.
Select the list item PT100/PT1000.
Select the temperature probe.
Select SPECIAL FUNCTION\SYSTEM SETTINGS\PROC.
INPUTS. Press ENTER.
Select the list item LINK OTHERS.
Select the first input to be linked to measuring channel A.
Only the installed inputs are displayed in the scroll list.
Select the list item NO MEASURING if an input is not to be
linked to measuring channel A.
Press ENTER.
A:T-Inlet 
Input T1
SYSTEM settings 
Proc. inputs
Proc. inputs 
PT100 / PT1000
Input T1 
>PT100< pt1000
SYSTEM settings 
Proc. inputs
Proc. inputs 
Link others
A:ext.Input(1)
Input I1