Flexim FLUXUS G704 - SYSTEM SETTINGS\GAS-MEASURING

UMG70XV3-4EN 12.01.2009 221
B Menu Structure
input of an upper limit of the flow velocity
range: 0.1...25.5 m/s
All measured values exceeding the limit will
be marked as outliers.
Input of 0 (zero) switches off the detection for
outliers.
x
selection of the unit of measurement for the
heat quantity
x
activation of output and storing of the heat
quantity totalizer values during heat flow
measurement
x
activation of the overflow of the totalizers x
activation of the taking-over of the totalizer
values after restart of the measurement
x
SYSTEM SETTINGS\GAS-MEASURING
selection of the displays for the input of the
standard conditions for gas measurement
This display is indicated only if SPECIAL
FUNCTION\SYSTEM SETTINGS\MEASUR-
ING\GAS-MEASURING has been activated.
input of the pressure for the local standard
conditions
range: 0.70001...1.30000 bar
input of the temperature for the local standard
conditions
range: -20.0...+90.0 °C
cold start
resistant
Velocity limit
0.0 m/s
Heat Quantity
>[J]< [Wh]
heat+flow quant.
off >ON<
Quant. wrapping
off >ON<
Quantity recall
off >ON<
SYSTEM settings 
Gas-Measuring
Normal pressure
1.01325 bar
Normal temper.
0.0 C