Flexim FLUXUS G704 - SYSTEM SETTINGS\SERIAL TRANSMIS.

UMG70XV3-4EN 12.01.2009 223
B Menu Structure
activation of storing of the concentration of
the medium
This display is indicated only if SYSTEM
SETTINGS\MEASURING\ENABLE CONCEN-
TR. (option) has been activated.
The value will be stored only if the data mem-
ory is activated.
x
activation of an acoustic signal for each stor-
ing or transmission of a measured value
x
SYSTEM SETTINGS\SERIAL TRANSMIS.
selection of the displays for the formatting of
the serial transmission of measured values
activation of the serial transmission with
blanks
selection of the decimal marker for floating
point numbers
selection of the character for column separa-
tion
selection of the serial interface
default: RS232
This display will be indicated only if the flow-
meter has an RS485 interface.
SYSTEM SETTINGS\NETWORK
change of the settings of the transmission pa-
rameters
cold start
resistant
Store Concentr.
off >ON<
Beep on storage
>ON< off
SYSTEM settings 
serial transmis.
SER:kill spaces
off >ON<
SER:decimalpoint
’.’ >’,’<
SER:col-separat.
’;’ >’TAB’<
Send Offline via
RS232 >RS485<
SYSTEM settings 
Network