Flintec FT-111 - Setup, Backup, and Restore via Indface2 x Software; Firmware Upgrade; Copying Weighing-Related Data from SD Card to PC

FT-111, User Manual Rev. 2.0.0, June 2022 Page 32 of 137
Back up
1. Insert a FAT32 formatted SD card with 16Gb max. and into the SD card slot (Refer to Section11.3).
2. Enter the programming mode, select the parameter 961 and then press key (Refer to Section 8).
Restore
1. Insert the SD card having the backup of all the data into the SD card slot (Refer to Section11.3).
2. Enter the programming mode and go to parameter 962.
3. Select All or set-up or calibration and then press key (Refer to Section 8).
5.4 SETUP, BACKUP AND RESTORE VIA INDFACE2X SOFTWARE
Set-up and programming of FT-111 can be done via IndFace2X PC software.
1. Download free IndFace2X software from Flintec web page and install it into your PC,
2. Connect FT-111 to the PC via USB port, RS232C port or Ethernet port.
3. Set port parameters of software to indicator parameters after energizing the instrument.
4. Click connect button.
5. Please refer to Indface2x software document for further information.
5.5 FIRMWARE UPGRADE
For the firmware upgrade you need a PC with Windows 10 operating system and a micro-USB cable. Please
refer to FT-11x Weighing Terminal Firmware Update document to load the new firmware.
5.6 COPYING THE WEIGHING-RELATED DATA FROM SD CARD TO A PC
FT-111 has data logging feature that can record all weighing-related data to the SD card. This data can be
transferred to a PC, as explained below.
1. Prepare a PC with a terminal program such as Hyperterminal.
2. PC to FT-111 connection can be done in two ways.
a. Direct connection via RS232/485/Ethernet/USB
b. Via local area network. If PC and FT-111 are connected to the same local area this connection can be
made. After Ethernet connection enter the IP number of FT-111 to the terminal program.
3. Select the data format of the port connected to FT-111 as BSI and make other necessary communication
settings for the port accordingly (Refer to page 46).
4. 11.4)
5. After sending "L" command, the data in the SD card is copied to the PC. Save data to PC when copying is
finished.
6. After saving the data, send the "E" BSI command to delete the data in the SD card.