Flintec FT-111 - Ethernet TCP;IP

FT-111, User Manual Rev. 2.0.0, June 2022 Page 99 of 137
11.8 ETHERNET TCP/IP
Ethernet output of FT-111 is programmable to BSI command set, Continuous data output, Fast continuous
data output, Modbus TCP/IP High-Low, Modbus TCP/IP Low-High. The first three data structures can be find
in the related sections indicated in the table below.
Data Format
Description
BSI Command set
Refer to Page 77.
Continuous
Refer to Page 39, 88.
Fast Continuous
Refer to Page 40.
Modbus TCP High-Low
Modbus TCP interfacing.
Refer to Page 100 .
Modbus TCP Low-High
Modbus TCP interfacing.
Refer to Page 100 .
Table 11-1 - Ethernet output interfacing
You can communicate with FT-111 after programming Ethernet TCP/IP and Modbus TCP related parameters
[15-].
11.8.1 Ethernet Parameters
Ethernet parameters can be adjusted by keys in programming mode. Refer to parameter block [15-].
Additionally, Ethernet parameters set up is done by EtherX PC software over Local Network Area or by
IndFace2x.The software are available on www.flintec.com
Parameters
Descriptions
Host Name
Device name of the instrument. Refer to parameter 255.
IP Address
Obtain IP address manually. Refer to parameter 152.
Local Port
Ethernet connection port of the instrument. Refer to parameter 156.
Gateway
Network point that acts as an entrance to another network.
Refer to parameter 155.
Subnet Mask
Describes IP address can be used in network. Refer to parameter 154.
Primary DNS
Obtain primary DNS manually. Refer to parameter 159.
Secondary DNS
Obtain secondary DNS manually.
Remote Connection
Check Box
Automatic connection to any device on the network. Refer to parameter
15E and 15F
Remote IP Address
IP address of the PC, Printer or Device to be connected automatically.
Enter IP address of the remote device.
Remote Port
Ethernet connection point of PC, Printer or Device to be connected
automatically. Enter port number of the remote device.
Password
Default password is 123456.
Set Defaults
Sets factory defaults.