Flintec FT-111 - BSI-Base Commands

FT-111, User Manual Rev. 2.0.0, June 2022 Page 82 of 137
11.4.1 BSI-Base Commands
BSI-BASE Command Table:
Description
Command
Response
Read all weight data
immediately
[ADR][A]
[ADR][A][STATUS][SIGN][NET W]
[SIGN][TARE W] [SIGN] [GROSS W]
Read Gross weight value
immediately
[ADR][B]
[ADR][B][STATUS][SIGN][WEIGHT
VALUE]
Clear the tare memory
[ADR][C]
[ADR][C][A]
Read the last printed data
[ADR][DO]
[ single line data format ]
Print the label
[ADR][DJ]
[ADR][DJ][A]
Read stable weight and
Record to Alibi
[ADR][DV]
[ADR][DV][A][STATUS][SIGN][NET W]
[SIGN][TARE W][SIGN] [GROSS W]
[ALIBI NUMBER]
Erase all data loggings on
the SD card.
[ADR][E]
[ADR][E][A]
Start / stop continuous data
output
[ADR][F] [X]
X=0; Disable
X=1; Enable
[ADR][F][A]
Read voltage value of DC
power supply
[ADR][G]
[ADR][G][STATUS][VOLTAGE VALUE]
Read current weight
(indicated) value
immediately
[ADR][I]
[ADR][I][STATUS][SIGN][WEIGHT
VALUE]
Read all data logging in the
SD card
[ADR][L]
[ADR][L][A][All DATA]
Read the scale name
[ADR][N]
[ADR][N][A][16 digits]
Read the stable weight
[ADR][P]
[ADR][P][STATUS][SIGN][WEIGHT
VALUE]
Load set points
[ADR][Q][SP No][L][SIGN][SP
VALUE]
[ADR][Q][STATUS]
Read set points
[ADR][R][SP No][L]
[ADR][R][STATUS][SIGN][SP VALUE]
Read Status
[ADR][S]
[ADR][S][STATUS-1][STATUS-2]
[STATUS-3]
Tare
[ADR][T]
[ADR][T][STATUS]
Read digital inputs
[ADR][U]
[ADR][U][STATUS][Inputs]
Read digital outputs
[ADR][V]
[ADR][V][STATUS][Outputs]
Command: 01P[CHK][CR][LF]
Checksum
=
0x31 + 0x50)
=
=
0x4F
=
Response: 01PS+000123.4[CHK][CR][LF]
Checksum
=
0x2E + 0x34)
=
=
0x49
=