Flintec FT-111 - Page 83

FT-111, User Manual Rev. 2.0.0, June 2022 Page 83 of 137
Set/Reset digital outputs
[ADR][W][Outputs]
[ADR][W][STATUS]
Read weight value in
increased resolution
[ADR][X]
[ADR][X][STATUS][SIGN][WEIGHT
VALUE]
Zero
[ADR][Z]
[ADR][Z][STATUS]
BSI-Base Commands and Responses:
A
Read all weight data immediately
B
Read Gross weight value immediately
C
Clear the tare
DO
Read the last printed data
DJ
Print the label
DV
Read stable weight and Record to Alibi
E
Erase the logs in the SD card.
F
Start /stop continuous data output
G
Read voltage value of DC power supply
I
Read current weight (indicated) value immediately
L
Read the logs in the SD card.
N
Read the scale name
P
Read the current stable weight value
Q
Load set point values
R
Read set point values
S
Read Status
T
Tare
U
Read digital inputs
V
Read digital outputs
W
Set/Reset digital outputs
X
Read current weight value in increased resolution immediately
Z
Zero
A
Read all weight data
Command : [ADR][A]
Response : [ADR][A][STATUS][SIGN][NET W][SIGN][TARE W][SIGN][GROSS W]
Example :
Command : 01A
Response : 01AS+000123.4+000111.1+000234.5
01AD+000123.4+000111.1+000234.5
01AO (ADC out error )
Comments :
The response is net, tare and gross weight values or error status.
All weight data is transmitted immediately after receiving the command.
B
Read Gross weight
Command : [ADR][B]
Response : [ADR][B][STATUS][SIGN][WEIGHT VALUE]
Example :
Command : 01B
Response : 01BS+000123.4 (gross weight is stable and 123.4)
01BD+000123.4 (gross weight is dynamic and 123.4)
(under load)
Comments :
The response is the gross weight value (stable or dynamic) or error status.
Gross weight data is transmitted immediately after receiving command.