Flintec FT-111 - [2- CONFIGURATIO] Configuration Block

FT-111, User Manual Rev. 2.0.0, June 2022 Page 56 of 137
[2-- CONFIGURATIO] Configuration Block
[
2--
CONFIGURATIO
]
CONFIGURATION MAIN BLOCK
Press key sequentially to access this main block,
or press or key to enter configuration parameters,
or press key to go to the next block,
or press key to exit from programming.
[
21-
DSPLY ACUSTI
]
DISPLAY AND ACOUSTIC
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
211
LIGHT
:
ON
]
Backlight
OFF
ON
AUTO
:
:
:
Backlight disabled.
Always bright.
Automatic backlight to increase the battery life.
[
212
COLOR
:
TURQ
]
Backlight color
WHIT
LGRE
GREE
TURQ
:
:
:
:
White
Light Green
Green
Turquoise
BLUE
YELL
AMBE
RED
:
:
:
:
Blue
Yellow
Amber
Red
[
213
KEYSOUN
:
YES
]
Key sound
NO
YES
:
:
Disable
Enable
[
214
REFRESH
:
5
]
Display refresh rate
X
:
1...9 times/sec
[
22-
INFO DISPLAY
]
INFORMATION DISPLAY
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
221
TIME
:
D+T
]
Information data on the right of the alphanumeric display.
NO
T
D
D+T
:
:
:
:
No clock data on the display.
Display time,
Display date,
Display date and time,
[
222
DATA
:
TARE
]
Information data on the left of the alphanumeric display.
NO
TARE
GROS
:
:
:
No data
Tare weight is displayed
Gross weight is displayed in Net
Note: The par 221 is set to NO, if this parameter is not programmed
NO, TARE or GROS.
[
23-
START UP
]
START UP
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
231
TARING
:
MULT
]
Taring.
Page 29
NO
MULT
GROS
:
:
:
Disabled.
Tare with key, via serial interface or via digital input.
Tare with key, via serial interface or via digital input only
at gross.