Flintec FT-111 - Metrology Block

FT-111, User Manual Rev. 2.0.0, June 2022 Page 65 of 137
[8-- METROLOGY] Metrology Block
[
8--
METROLOGY
]
METROLOGY MAIN BLOCK
Press key sequentially to access this main block,
or press or key to enter configuration parameters,
or press key to go to the next block,
or press key to exit from programming.
[
81-
ALIBI MEMORY
]
ALIBI MEMORY
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
811
ALIBI
:
NO
]
M
Alibi memory
Page 77
NO
YES
:
:
Disable
Enable
[
812
PORT
:
PRNT
]
Select the Alibi data transfer port.
PRNT
R232
USB
ETH
:
:
:
:
to the printer port.
to the RS232C.
to the USB
to the Ethernet TCP/IP.
[
813
ACCESS
:
NUM
]
Access to the Alibi memory record
Page 77
NUM
DATE
CN
:
:
:
Search by Alibi number
Search by date
Search by Consecutive value
[
814
TRANSFER
:
NO
]
Transfer Alibi memory records
Page 77
NO
ALL
:
:
No
Transfer alibi memory record to
the printer port
[
815
ALIBI ABOUT
]
Transfer alibi memory information.
Page 77
[
816
FORMAT
:
NO
]
M
Format alibi memory SD card.
Page 77
NO
YES
:
:
No
Start formatting alibi SD card.
Attention : Only authorized person !!!
[
82-
INFORMATION
]
METROLOGIC INFORMATION
Press key or key again to enter this menu.
Press key to go to the beginning of the sub-block or press
key to go to the next main block.
[
821
CAL COUNTER
]
This counter announces interfering quantity to the instrument with
service password when calibration switch enabled. Count number
increases at exit from set-up mode if service password is used and
calibration is enabled to enter set-up mode.
[
822
CONFIG COUNT
]
This non-resettable and protected counter announces interfering
quantity to the instrument. Count number increases at every exit
from set-up mode.
[
823
NEXT VERIFIC
]
Date of the next verification