Flintec FT-111 - Diagnostic Block

FT-111, User Manual Rev. 2.0.0, June 2022 Page 66 of 137
[9-- DIAGNOSTIC] Diagnostic Block
[
9--
DIAGNOSTIC
]
DIAGNOSTIC MAIN BLOCK
Press key sequentially to access this main block,
or press or key to enter configuration parameters,
or press key to go to the next block,
or press key to exit from programming.
[
91-
HARDWARETEST
]
HARDWARE TESTING
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
911
KEY
]
Key testing
[
912
RS232-1
]
RS232C-1 serial port testing
[
913
RS232-2
]
RS232C-2 serial port testing
[
914
RS485
]
RS485 serial port testing
[
915
USB
]
USB port testing
[
916
IN / OUT
]
Digital Input / Output testing
[
917
DISPLAY
]
Display testing
[
918
LC SIGNAL mV
]
Load cell signal measuring in millivolt
[
919
PRINTER
]
Printer testing
[
92-
HISTORY
]
HISTORY
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
921
PEAK LOAD
]
The last 20 peak loads listed in this parameter.
[
922
UNDER LOGS
]
The last 20 under errors listed in this parameter.
[
923
ERROR LOGS
]
The last 20 errors listed in this parameter.
[
924
ENTRY LOGS
]
The last 20 Service/User entry listed in this parameter.
[
96-
BACKUP / RECOVE
]
BACKUP / RECOVER
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
961
BACK UP
:
ALL
]
Backup the instrument to SD card.
ALL
Backup of all the instrument parameter to SD
card.
Page 31
[
962
RECOVER
:
RCPT
]
M
Restore the instrument from SD card.
Page 31
SETP
Parameters of 1--, 2-- and 3-- parameter groups.
CAL
Parameter group 5-- and calibration coefficients.
ALL
All parameters and calibration
WARNING: CAL and ALL items can be loaded if the calibration dip switch
is at ON position.
[
963
WEB BACK UP
]
Back up the instrument to the PC via web service.