Flintec FT-111 - Page 84

FT-111, User Manual Rev. 2.0.0, June 2022 Page 84 of 137
C
Clear the tare memory
Command : [ADR][C]
Response : [ADR][C][A] (Cleared and the scale is in gross mode)
Comments:
The response status is always Ack in weighing or force mode.
DO
Read the last printed data
Command : [ADR][DO]
Response : [single line data format]
Example :
Command: 01DO
Response: G: 53.55kg T: 0.00kg N: 53.55kg
Comments:
The last printed values are transmitted immediately after receiving the command.
Single line data format can be change due to its configuration. Refer to section 7.3 and sub-block [16].
DJ
Print the label
Command : [ADR][DJ]
Response : [ADR][DJ][ STATUS]
Example :
Command : 01DJ
Response : 01DJA (Weight is stable and printed) or
01DJN (Could not print)
Comments:
Checks status and it must be stable. Else Nack status is send.
Status can be Stable or Nack.
DV
Read stable weight and Record to Alibi
Command : [ADR][DV]
Response : [ADR][DV][STATUS][SIGN][NET W][SIGN][TARE W][SIGN][GROSS W][ALIBI NUMBER]
Example :
Command : 01DV
Response : 01DVS+000123.4+000111.1+000234.5*00001*
01DVO (ADC out error)
Comments :
The response is net, tare, gross weight and alibi number values or error status.
All weight data is transmitted immediately after receiving the command if weight is stable.
E
Erase the all data logging in the SD card
Command : [ADR][E]
Response : [ADR][E][ STATUS]
Example :
Command : 01E
Response : 01EA (All data logging erased) or
01EN (Data logging could not erased)
Comments:
Acknowledge (ACK) is transmitted after all data logging erased.
F
Start /stop continuous data output
Command : [ADR][F][ENABLE/DISABLE]
Response : [ADR][F][STATUS]
Example :
Command : 01F1 (Enable)
01F0 (Disable)
Response : 01FA (Command is done successfully)
01FN (Command could not executed)
Comments: Indicated weight value sends continuously.
Continuous data format is [ADR][I][STATUS][SIGN][WEIGHT VALUE].