Flintec FT-111 - Page 50

FT-111, User Manual Rev. 2.0.0, June 2022 Page 50 of 137
SARTOR
LM2
LLINE2
:
:
:
Commonly used by Sartorious.
Flintec LM2 (par.000=6 )
Commonly used by Tunaylar
[
142
CSUM
:
NO
]
Checksum at continuous and BSI formats.
NO
YES
:
:
Checksum disable
Checksum enable
[
143
CR
:
YES
]
Carriage return at continuous formats.
NO
YES
:
:
Carriage return disable
Carriage return enable
[
144
LFEED
:
YES
]
Line feed at continuous formats.
NO
YES
:
:
Line feed disable
Line feed enable
[
145
DELAY
:
50
]
Data output delay at BSI formats; delay between continuous format
data.
[
15-
ETHERNET
]
ETHERNET TCP/IP
Press key or key again to enter this menu.
Or press key to go to the next sub-block.
[
151
FORMAT
:
NO
]
Data format of the Ethernet port
Page 39,
22
NO
CONT
FAST
PRNT
:
:
:
:
Port is disabled
Continuous data output
High speed continuous data output
Printout
BSI
MBHL
MBLH
:
:
:
BSI format for PC, PLC interface
Modbus TCP High-Low format
Modbus TCP Low-High format
Press key to select output format different than Flintec
continuous data format while the selection is CONT in the
information display. Available functions are seen on the weight
display after pressing key sequentially. Press key after
selecting the data format.
Refer to page 88 for details of data structure.
[
FLINTEC
]
FLINTEC
HBM
TOLEDO
SYSTEC
SMA
BASTER
RINSTR
AVERY
SARTOR
LM2
LLINE2
:
:
:
:
:
:
:
:
:
:
:
Flintec continuous format.
Commonly used by HBM, GSE, PT, Systec, Rinstrum.
Commonly used by Toledo, Mettler Toledo.
Commonly used by Systec.
Commonly used by USA producers, Cardinal, Rice Lake etc.
Commonly used by Baster.
Commonly used by PT, Rinstrum, HBM, GSE.
Commonly used by Avery E1205.
Commonly used by Sartorious.
Flintec LM2 (par.000=6 )
Commonly used by Tunaylar.
[
152
IP
:
250
]
IP address.
Default is 192.168.016.250
[
153
ADDRESS
:
01
]
Address of the port
00 means data format without address.
[
154
SUB MASK
:
000
]
Subnet mask address.
Default is 255.255.255.000