FMC Technologies Proline Promass 83 E - Function Group FLOW COEFFICIENT

Issue/Rev. 0.2 (12/12)
Page 136 • MN0M023
9 Block BASIC FUNCTION Device Functions Proline Promass 83
9.4.2 Function group FLOW COEFFICIENT
BASIC FUNCTION G

HART GAA

PROCESS PARAMETER GIA

SYSTEM PARAMETER GLA

SENSOR DATA GNA

CONFIGURATION 680

FLOW COEFF. 684
Function description
BASIC FUNCTION o SENSOR DATA o FLOW COEFFICIENT
All flow coefficients are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
Contact the E+H service organization if you have any questions about these functions.
TEMPERATURE
COEFFICIENT KM
(6840)
This function shows the temperature coefficient KM.
TEMPERATURE
COEFFICIENT KM 2
(6841)
This function shows the temperature coefficient KM 2.
TEMPERATURE
COEFFICIENT KT
(6842)
This function shows the temperature coefficient KT.
CALIBRATION
COEFFICIENT KD 1
(6843)
This function shows the calibration coefficient KD 1.
CALIBRATION
COEFFICIENT KD 2
(6844)
This function shows the calibration coefficient KD 2.