FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12)
Page 26 • MN0M023
4 Block QUICK SETUP Device Functions Proline Promass 83
QUICK SETUP
BATCHING/DOSING
(1005)
! Note!
This function is only available when the optional software package BATCHING is
installed.
Use this function to start the (optional) application specific Setup menu for batching.
Options:
YES
NO
Factory setting:
NO
! Note!
You will find a flowchart of the BATCHING setup menu on page 32. For more
information on Setup menus, please refer to the Operating Instructions
Proline Promass 83, BA 059D/06/en.
T-DAT SAVE/LOAD
(1009)
Use this function to save the parameter settings / configuration of the transmitter in a
transmitter DAT (T-DAT), or to load the parameter settings from the T-DAT into the
EEPROM (manual safety function).
Application examples:
• After commissioning, the current measuring point parameters can be saved to the
T-DAT as a backup.
• If the transmitter is replaced for some reason, the data from the T-DAT can be loaded
into the new transmitter (EEPROM).
Options:
CANCEL
SAVE (from EEPROM to T-DAT)
LOAD (from the T-DAT into EEPROM)
Factory setting:
CANCEL
! Note!
• If the target device has an older software version, the message “TRANSM. SW–DAT”
is displayed during startup. Then only the “SAVE” function is available.
• LOAD
This function is only possible if the target device has the same software version as, or a
more recent software version than, the source device.
•SAVE
This function is always available.
Function description
QUICK SETUP