FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12) MN0M023 • Page 99
Device Functions Proline Promass 83 7 Block OUTPUTS
Function description
OUTPUTS o PULSE/FREQUENCY OUTPUT (1...2) o OPERATION (STATUS)
ACTUAL STATUS
(4341)
! Note!
This function is not available unless the STATUS setting was selected in the OPERATION
MODE function (4200).
Use this function to check the current status of the status output.
Display:
NOT CONDUCTIVE
CONDUCTIVE
SIMULATION SWITCH
POINT
(4342)
! Note!
This function is not available unless the STATUS setting was selected in the OPERATION
MODE function (4200).
Use this function to activate simulation of the status output.
Options:
OFF
ON
Factory setting:
OFF
! Note!
• The “SIMULATION STATUS OUTPUT” message indicates that simulation is active.
• The measuring device continues to measure while simulation is in progress, i.e. the
current measured values are output correctly via the other outputs.
" Caution!
The setting is not saved if the power supply fails.
VALUE SIMULATION
SWITCH POINT
(4343)
! Note!
This function is not available unless STATUS was selected in the OPERATION MODE
function (4200) and the SIMULATION SWITCH POINT function (4342) is active
(= ON).
Use this function to define the switching response of the status output during the
simulation. This value is used to test downstream devices and the measuring device itself.
Options:
NOT CONDUCTIVE
CONDUCTIVE
Factory setting:
NOT CONDUCTIVE
" Caution!
The setting is not saved if the power supply fails.