FMC Technologies Proline Promass 83 E - Function Group ADDITIONAL COEFFICIENT

Issue/Rev. 0.2 (12/12)
Page 138 • MN0M023
9 Block BASIC FUNCTION Device Functions Proline Promass 83
9.4.4 Function group ADDITIONAL COEFFICIENT
BASIC FUNCTION G

HART GAA

PROCESS PARAMETER GIA

SYSTEM PARAMETER GLA

SENSOR DATA GNA

CONFIGURATION 680

FLOW COEFF. 684

DENSITY COEFFICIENT 685

ADDITIONAL
COEFFICIENT
686
Function description
BASIC FUNCTION o SENSOR DATA o ADDITIONAL COEFFICIENT
All sensor data are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
" Caution!
These functions are used for displaying device parameters only and consequently cannot be accessed.
Contact the E+H service organization if you have any questions about these functions.
MINIMUM FLUID
TEMPERATURE
(6860)
The lowest fluid temperature measured appears on the display.
MAXIMUM FLUID
TEMPERATURE
(6861)
The highest fluid temperature measured appears on the display.
MINIMUM TEMP.
CARRIER TUBE
(6862)
! Note!
This function is not available for the Promass E measuring device.
The lowest carrier tube temperature measured appears on the display.
MAXIMUM
TEMPERATURE CARRIER
TUBE
(6863)
! Note!
This function is not available for the Promass E measuring device.
The highest carrier tube temperature measured appears on the display.