FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12) MN0M023 • Page 21
Device Functions Proline Promass 83 3 Block MEASURED VARIABLES
UNIT TEMPERATURE
(0422)
Use this function to select the unit for displaying the temperature.
The unit you select here is also valid for:
• Current outputs
• Frequency outputs
• Current input
• Relay switch points (limit value for temperature)
• Reference temperature (for corrected volume measurement with measured
reference density)
Options:
°C (Celsius)
K (Kelvin)
°F (Fahrenheit)
°R (Rankine)
Factory setting:
°C
UNIT LENGTH
(0424)
Use this function to select the unit for displaying the length of the nominal diameter.
The unit you select here is valid for:
• Nominal diameter of sensor (function NOMINAL DIAMETER (6804) on page 135)
Options:
MILLIMETER
INCH
Factory setting:
MILLIMETER
UNIT PRESSURE
(0426)
Use this function to select the unit for pressure.
The unit you select here is valid for:
• Specified pressure (see function PRESSURE (6501) on page 132)
Options:
bar a
bar g
psi a
psi g
Factory setting:
bar g
Function description
MEASURED VARIABLES o SYSTEM UNITS o ADDITIONAL CONFIGURATION