FMC Technologies Proline Promass 83 E - Function Description

Issue/Rev. 0.2 (12/12) MN0M023 • Page 145
Device Functions Proline Promass 83 10 Block SPECIAL FUNCTION
CONCENTRATION
SELECTOR
(7022)
Use this function to select a concentration specification. There are four different
concentration specifications available, via which various concentrations can be defined.
Options:
CONC. # 1 (or the name that has been defined in the function CONCENTRATION
NAME (7031) for concentration specification 1)
CONC. # 2 (or the name that has been defined in the function CONCENTRATION
NAME (7031) for concentration specification 2)
CONC. # 3 (or the name that has been defined in the function CONCENTRATION
NAME (7031) for concentration specification 3)
CONC. # 4 (or the name that has been defined in the function CONCENTRATION
NAME (7031) for concentration specification 4)
Factory setting:
CONC. # 1
! Note!
• By selecting a concentration specification and the (subsequent) relevant settings, up to
4 different concentrations can be preconfigured and selected when needed.
• All settings in the subsequent functions of this function group are each only valid for
the concentration specification selected in the function CONCENTRATION
SELECTOR (7022). In other words, the entry or option is assigned to the
concentration specification currently selected (e.g. in the factory setting CONC. # 1).
CONCENTRATION
NAME
(7031)
Use this function to assign a specific name to the concentration specification.
User input:
max. 8-character text, permissible: A-Z, 0-9
Factory setting:
Name of concentration specification (depends on selection in the function
CONCENTRATION SELECTOR (7022), e.g. “CONC. # 1”).
COEFFICIENT A0
(7032)
Coefficient A0 entry.
User input:
5-digit floating-point number
Factory setting:
0
COEFFICIENT A1
(7033)
Coefficient A1 entry.
User input:
5-digit floating-point number
Factory setting:
0
Function description
SPECIAL FUNCTION o DENSITY FUNCTIONS o CONFIGURATION