FMC Technologies Proline Promass 83 E - Function Group ACQUISITION

Issue/Rev. 0.2 (12/12) MN0M023 • Page 167
Device Functions Proline Promass 83 10 Block SPECIAL FUNCTION
10.3.2 Function group ACQUISITION
SPECIAL FUNCTION H

ADVANCED DIAGNOSIS HEA

CONFIGURATION 740

ACQUISITION 741
Function description
SPECIAL FUNCTION o ADVANCED DIAGNOSIS o ACQUISITION
ACQUISITION MODE
(7410)
Use this function to specify whether the advanced diagnosis parameters should be
determined on a periodical or single-shot basis.
Options:
OFF
PERIODICAL
SINGLE SHOT
Factory setting:
OFF
! Note!
See the Chapter on “Commissioning” in the Operating Instructions Proline Promass 83,
BA 059D/06/en for more information on advanced diagnosis.
ACQUISITION PERIOD
(7411)
! Note!
This function is not available unless PERIODICAL was selected in the ACQUISITION
MODE function (7410).
Use this function to specify the time interval after which the advanced diagnosis
parameters should be taken. The time interval starts with the confirmation of the input.
User input:
0...99999 s
Factory setting:
3600 s
! Note!
A reference status must be defined prior to determining the diagnosis parameters,
see function SELECT REFERENCE CONDITION (7402).
ACQUISITION DO
(7412)
! Note!
This function is not available unless SINGLE SHOT was selected in the ACQUISITION
MODE function (7410).
Use this function to start determining the advanced diagnosis parameters on a single-shot
basis.
Options:
START – CANCEL
Factory setting:
CANCEL
! Note!
A reference status must be defined prior to determining the diagnosis parameters,
see function SELECT REFERENCE CONDITION (7402).
RESET HISTORY
(7413)
Use this function to delete all history values.
Options:
YES – NO
Factory setting:
NO